Adhesive Cable Clips, Set of 100 in Black for Flat Network and Low-Voltage Wire

One hundred small adhesive clips for routing flat network cable along a baseboard, behind a desk or under a dashboard without drilling a single hole. Peel the release paper, press the clip where the cable should run, and the wire stays where you put it.

They hold on metal, plastic, glass, wood, light-grain plastic and tile. Soft and textured surfaces are not suitable, so skip plush finishes and limewashed walls.

• Wipe the surface clean before sticking anything down.
• Press for five seconds — on an uneven wall press each of the four corners for at least seven seconds.
• The adhesive reaches full strength after about 48 hours, so leave it alone rather than tugging at it to test the hold.

To take a clip off, lift it away; it releases without leaving residue behind on the wall.